The following procedure varies depending on BIOS version.
For BIOS version 2.02a1, perform the following procedure.
For BIOS version 2.12a13, skip to
card when BIOS version is 2.12a13 on page
7
The BIOS utility is displayed. Enter < number > and then press Enter
.
key.
< number > : 1 or 3 the first port number of the replaced card
8
Confirm and record Port Name and Node name.
.
9
Enter 2, and then press Enter key to confirm registered boot device.
.
10
The parameter List is displayed.
.
11
Enter < number > from 1 to 11 respectively to set up each parameter,
.
and then press Enter key.
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
Restoring parameter of FC mezzanine
7-23.
7-19