Hitachi CB 520H B1 Service Manual page 202

3 Align the three alignment holes of mezzanine card with the guide pins, as
.
shown below.
4 Reverse the removal procedure.
.
5 Configure the parameters in the case of replacing Emulex HBA card.
.
See
6 Perform
.
Notice:
Restriction; The half wide server blade with LOM cannot install the
mezzanine card at the slot number 1 because the LOM pass through
connector is already mounted in the server blade that supported the LOM.
The LOM pass through connector is not a replaceable component.
5-50
Figure 5-63 Removing the connector cover
Configuration procedure for Emulex HBA card on page 7-2
Installing a half-wide server blade on page 5-5
Figure 5-64 Installing the mezzanine card
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
procedure.