Installing A Front Panel Module; Replacing A Usb Memory In The Front Panel Module - Hitachi CB 520H B1 Service Manual

3 Turn on the maintenance mode from web console.
.
See
4 Release the two thumbscrews, as shown below.
.
5 Hold the two thumbscrews and pull the front panel module out of the
.
server chassis.
6 Remove the USB memory from the failed front panel module.
.
See
Note: The USB memory removed from the failed front panel module in step 6
is reinstalled to the spare front panel module.
The configuration data of server blade and management module is stored in
it.
Make sure not to misplace it absolutely.

Installing a front panel module

1 Put on an anti-static wrist strap.
.
2 Install the USB memory to the spare front panel module.
.
See
3 Reverse the removal procedure.
.
4 Turn off the maintenance mode from web console.
.
See
5 Verify that the replacement was successful through the MAR log.
.
See

Replacing a USB memory in the front panel module

This procedure describes how to remove a USB memory from the front panel
module.
Maintenance mode on/off procedure on page 4-10
Removing a USB memory on page 5-126
Figure 5-157 Removing a front panel module
Installing a USB memory on page 5-126
Maintenance mode on/off procedure on page 4-10
Alert information identification procedure on page 4-5
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
section.
section.
section.
section.
5-125