Installing An Sfp+ Module - Hitachi CB 520H B1 Service Manual

See
5 Remove a cable from the failed FC port.
.
6 While holding the pull tab of the optical module, pull out the module
.
straight forward.

Installing an SFP+ module

SFP+ module for LAN switch/8Gb FC switch/DCB switch/LAN pass trough
1 Put on an anti-static wrist strap.
.
2 If the dust cap is put in the spare SFP+ module as shown in the following
.
figure, remove it first.
3 Close the lever, and then push in the SFP+ module.
.
4 Verify that the replaced SFP is running normally.
.
Maintenance mode on/off procedure on page 4-10
Figure 5-145 Removing an SFP+ module in 16Gb FC switch
Figure 5-146 Removing the dust cap
Figure 5-147 Installing an SFP+ module
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
5-115