Updating Bmc/Efi Firmware On Server Blade - Hitachi CB 520H B1 Service Manual

Updating BMC/EFI firmware on server blade

Tip: Before performing the following procedures, you must download the
updated firmware file from Hitachi Data System support portal to the console
PC.
1 [For CB 520A A1, CB 520H A1/B1/B2/B3/B4, CB 540A A1/B1, and Non-
.
SMP CB 520X B1/B2/B3]
Select Resources tab and select Modules > Server Blades > a target
blade that should update the firmware.
[For SMP CB 520X B1/B2/B3]
Select Resources tab and select Modules > Server Blades > Server
Blade n of the SMP configuration > a target blade that should
update the firmware.
2 Select Condition tab.
.
3 Click Action and then select Update Firmware.
.
4 The update dialog box is displayed. Click Browse and select the new
.
firmware file.
5 Click Confirm.
.
6 The confirmation dialog box appears. Click OK and then firmware update
.
will start.
7 After the firmware update process has completed, the successful message
.
dialog box appears. Click Close.
9-2
Figure 9-1 Select the updated firmware
Updating firmware
Hitachi Compute Blade 500 Series System Service Manual