Removing A Pci Expansion Blade From Server Chassis - Hitachi CB 520H B1 Service Manual

24 Turn off LID LED for identifying the target blade.
.
See
Notice:
Do not install the server blade without the top cover. The server chassis
has a mechanical security to prevent installation without the top cover.
Bypassing this security feature can cause serious server chassis or server
blade damage.

Removing a PCI expansion blade from server chassis

1 Put on an anti-static wrist strap.
.
2 Connect web console. See
.
section.
3 Power off the target server blade. See
.
4-58
4 Turn on LID LED for identifying the target blade. See
.
on/off procedure on page 4-7
5 Turn on the maintenance mode from web console. See
.
on/off procedure on page 4-10
6 Identify F/W version and take notes of it. See
.
procedure on page 4-22
7 Release the blue lock tab and pull the lever, as shown below.
.
8 Holding the server blade, carefully slide out from the chassis and place it
.
on an anti-static mat.
Notice:
Identify LED (LID) on/off procedure on page 4-7
section.
Figure 5-11 Removing the PCI expansion blade
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Web console login procedure on page 4-3
Power down procedure on page
section.
section.
section.
section.
Identify LED (LID)
Maintenance mode
F/W version identification
5-15