Installing A Sas-Kit 2 - Hitachi CB 520H B1 Service Manual

Installing a SAS-kit 2

1 Put on an antistatic wrist strap.
.
2 Connect the SAS cable to the HDD backplane board and the RAID
.
mezzanine card before installing.
CAUTION: To reduce the risk of the personal injury, connect the SAS
cable before the HDD backplane board and RAID mezzanine card are
installed in the server blade.
3 Reverse the removal procedure.
.
4 Place the SAS cable into the guide of the air duct.
.
5 Perform
.
Notice:
Place the SAS cable to the cable guide correctly.
If the cable is not in place correctly, that might cause serious damage to
the cable.
5-98
Figure 5-126 Connecting the SAS cable
Installing a full-wide server blade on page 5-7
Figure 5-127 Fixing the SAS cable- CB 540A A1/B1
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
procedure.