Installing a SAS-kit 1
1
Put on an anti-static wrist strap.
.
2
Reverse the removal procedure.
.
3
Perform
.
Replacing a SAS-kit 2 in half-wide server blade
This procedure describes how to remove a SAS-kit 2 from the server blade.
A SAS-kit 2 is composed of:
1
SAS cable
.
2
HDD backplane board
.
Removing a SAS-kit 2
1
Put on an anti-static wrist strap.
.
2
Remove the target server blade.
.
See
3
Open the top cover of the server blade. See
.
blade on page 5-38
4
Open the lock tabs, as shown below.
.
5
Lift up the RAID mezzanine card and remove it from the server blade
.
assembly.
CAUTION: To reduce the risk of the personal injury, do not disconnect
the SAS cable from RAID mezzanine card before removing it from server
blade assembly.
6
Slide the disk drives approximately 4 cm to disconnect with the HDD
.
backplane board.
7
Lift the HDD backplane board assembly and remove it from the server
.
blade assembly.
Installing a full-wide server blade on page 5-7
Removing a half-wide server blade on page 5-4
section.
Figure 5-116 Removing the RAID card
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
procedure.
section.
Opening a top cover, Server
5-93