Hitachi CB 520H B1 Service Manual page 114

7 Enter ag --modeshow, and then press Enter key. Confirm the message
.
and identify the switch operation mode.
Access Gateway mode is NOT enabled
Access Gateway mode is enabled
8 Skip this step when the switch is 8Gb FC switch module.
.
Enter mapspolicy --show -summary, and then press Enter key. Confirm
the message and identify the switch monitor mode.
MAPS is not enabled yet.
Active Policy is 'xxxx_policy'
9 Skip this step when the switch is 8Gb FC switch module or monitor mode
.
is Fabric Watch.
Enter mapsconfig --show, and then press Enter key. Confirm the
message in Configured Notification line and identify the MAPS action
settings.
The MAPS action settings are RASLOG, SNMP, SW_CRITICAL,
SW_MARGINAL, and SFP_MARGINAL, at the maximum.
4-26
Message
Message
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual
Switch operation mode
Native
Access Gateway
Switch monitor mode
Fabric Watch
Access Gateway