Replacing A Sas-Kit 1 In Full-Wide Server Blade; Removing A Sas-Kit 1 - Hitachi CB 520H B1 Service Manual

Replacing a SAS-kit 1 in full-wide server blade

This procedure describes how to remove a SAS-kit 1 from the server blade.
A SAS-kit 1 is composed of:
1 HDD backplane board
.

Removing a SAS-kit 1

1 Put on an anti-static wrist strap.
.
2 Remove the target server blade.
.
See
3 Open the top cover of the server blade. See
.
blade on page 5-38
4 Slide out the disk drives approximately 4 cm to disconnect with the HDD
.
backplane board.
5 While opening up both of the edges of the latch, push out the connector
.
cable.
6 Turn the cable counterclockwise about 90 degrees, and then remove the
.
anchorage of HDD backplane.
7 Pull out the HDD backplane board assembly.
.
5-92
Removing a full-wide server blade on page 5-6
section.
Figure 5-114 Removing the HDD
Figure 5-115 Removing the HDD backplane board
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
Opening a top cover, Server