Replacing A Lithium Battery In Management Module; Removing A Lithium Battery - Hitachi CB 520H B1 Service Manual

14 About five minutes later, the management module will reboot.
.
15 Verify that the power LED lights in green after blinking and the primary
.
LED is off.
16 Set up TOD if you need.
.
See
17 Verify that the replacement was successful through the MAR log.
.
See
18 Turn off the maintenance mode from web console.
.
See

Replacing a lithium battery in management module

This procedure describes how to remove a lithium battery from the
management module.

Removing a lithium battery

1 Put on an anti-static wrist strap.
.
2 Remove the target management module. See
.
module (redundant) on page 5-100
(non-redundant) on page
3 Tilt the lithium battery in the direction as indicated by the arrow, and then
.
lift it away from the battery holder.
Figure 5-140 Clearing the Boot disable mode
Time of Day (TOD) clock setup procedure on page 4-44
Alert information identification procedure on page 4-5
Maintenance mode on/off procedure on page 4-10
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
or Replacing a management module
5-106.
section.
section.
section.
Replacing a management
5-109