How To Verify The Sfp Function - Hitachi CB 520H B1 Service Manual

See
5 Turn off the maintenance mode from web console.
.
See
6 Verify that the replacement was successful through the MAR log.
.
See
7 Turn off LID LED for identifying the target module.
.
See
SFP+ module for 16Gb FC switch
1 Put on an anti-static wrist strap.
.
2 If the dust cap is put in the spare SFP+ module, remove it first.
.
3 Insert the optical module (SFP+), and then push it into the arrowed
.
direction as shown in the following figure.
4 Verify that the replaced SFP is running normally.
.
See
5 Turn off the maintenance mode from web console.
.
See
6 Verify that the replacement was successful through the MAR log.
.
See
7 Turn off LID LED for identifying the target module.
.
See

How to verify the SFP function

1 Connect the terminal software to check the SFP function.
.
2 Click Start > Programs > Accessories > Communications >
.
HyperTerminal to boot up terminal software.
3 The Connection Description window is displayed. Enter telnet1, and
.
then click OK.
5-116
How to verify the SFP function on page 5-116
Maintenance mode on/off procedure on page 4-10
Alert information identification procedure on page 4-5
Identify LED (LID) on/off procedure on page 4-7
Figure 5-148 Installing an SFP+ module in 16Gb FC switch
How to verify the SFP function on page 5-116
Maintenance mode on/off procedure on page 4-10
Alert information identification procedure on page 4-5
Identify LED (LID) on/off procedure on page 4-7
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
section.
section.
section.
section.
section.
section.
section.