Removing A Pci Expansion Blade From The Shelf - Hitachi CB 520H B1 Service Manual

Removing a PCI expansion blade from the shelf

1 Removing a PCI expansion blade with a server blade.
.
See
section.
2 Opening a top cover of server blade and PCI expansion blade.
.
See
cover, PCI expansion blade on page 5-40
3 Open a latch of the connector of the connection kit F/H in the PCI
.
expansion blade, and then pull out the connector straight upward.
See
4 Open two latches of the connection board in the server blade, and then
.
pull out the board straight upward.
See
5 (Skip this step when the connection kit L/P is not installed.)
.
Pull out the connector of the connection kit L/P in the PCI expansion blade
straight upward, and then turn over the connector toward server blade.
See
6 Loosen a thumbscrew of the connection bracket, and then remove the
.
bracket. See
5-31.
7 (Skip this step when the connection kit L/P is not installed.)
.
Pull out the connection board of the connection kit L/P in the server blade
straight upward. See
page
Removing a PCI expansion blade from server chassis on page 5-15
Opening a top cover, Server blade on page 5-38
Figure 5-33 Removing the connection kit F/H on page
Figure 5-33 Removing the connection kit F/H on page
Figure 5-34 Removing the connection kit L/P on page
Figure 5-35 Removing the connection bracket on page
Figure 5-36 Removing the connection kit L/P on
5-31.
Figure 5-32 Location of the connection kit
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
and Opening a top
section.
5-30.
5-30.
5-30.
5-29