Hitachi CB 520H B1 Service Manual page 425

Figure 9-6 Connecting to 8Gb / 16Gb FC switch module
5 Enter admin as login name, and then press Enter key.
.
6 Enter password as password, and then press Enter key.
.
7 Confirm that the command prompt is indicated.
.
8 Enter firmwareshow, and then press Enter key.
.
Confirm whether the firmware version is as same as the one of failed
switch.
If the firmware is same, the firmware update is not needed, so skip the
following steps.
Note: Skip the following procedure when the firmware version of failed
switch is v6.3.2d and the one of replaced switch is 6.3.2d1.
Hitachi Compute Blade 500 Series System Service Manual
Updating firmware
9-9