Replacing A Usb In Cb 520X B1/B2/B3; Removing A Usb - Hitachi CB 520H B1 Service Manual

Installing a USB enablement kit
1 Put on an anti-static wrist strap.
.
2 While holding the connector of the USB enablement kit, align the bumps
.
on the connector with the slits in the receptor on the main board, and
then insert the connector straight downward into the receptor.
3 Put in the air duct portion onto the DIMM.
.
4 Close the top cover. See
.
section.
5 Install the server blade. See
.
5-5

Replacing a USB in CB 520X B1/B2/B3

This procedure describes how to replace the USB from CB 520X B1/B2/B3.

Removing a USB

Note: The indicator of the USB location in the OS message varies depending
on the number of installed USBs.
Confirm the location of replaced USB depending on the following table.
[USB is not installed in the USB port on the front panel of the server blade]
Installed
N/A
Installed
[USB is installed in the USB port on the front panel of the server blade]
section.
USB port
port 1
N/A
Installed
Installed
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Closing a top cover, Server blade on page 5-39
Installing a half-wide server blade on page
port 2 port 1
/dev/sda
N/A
/dev/sda
Location indicator
port 2
N/A
/dev/sda
/dev/sdb
5-59