Switch Module - Hitachi Compute Blade 500 Series System Overview Manual

Table 1-14 Management Module Switches, Indicators and Connectors
Location
1
2
3
4
5
6
7
8
9
10
11
12
13

Switch Module

This section describes switch modules.
Overview
The backplane within the server chassis interconnects the switch module to
the server blades. Each server blade connects to the backplane and thus to
the switch modules through an onboard CNA or Mezzanine cards on the
server blade.
Name
LAN Link Speed LED
LAN Status LED
Management LAN Port #0
(MGMT0)
Management LAN Port #1
(MGMT1)
Maintenance LAN Port
(MAINT)
Serial Port (SER)
Shut Down switch (SHDN)
Heartbeat LED (HB)
Power LED (PWR)
Identify LED (LID)
Alarm LED (ALM)
Primary LED (MSR)
Remote LED (RMT)
System Overview
Hitachi Compute Blade 500 Series System Overview Guide
State
Yellow-On 1000BASE-T
Yellow-Blink Link communication.
Green-On 100BASE-TX
Green-Blink Link communication.
Off 10BASE-T or no link.
Green-On Link established.
Green-Blink Link communication.
- LAN port 0 for the management
network
- LAN port 1 for the management
network
- LAN port for maintenance
- Serial port for the management
module console.
- Press and hold for at least four
seconds to turn off the power.
Green-Blink F/W is active and working normally
Green-On Powered-on, normal operation.
Green-Blink The system is shutting down or
booting
Blue-On This module is identified.
Red-On Alarm, an error was detected
Green-On This module is currently active. i.e.
not standby
Green-On The management module is
accessed remotely.
Description
1-25