Replacing A Sas-Kit 1 In Half-Wide Server Blade - Hitachi CB 520H B1 Service Manual

See
section.
4 Set the DIP switch #3 (RTCRST) to the ON position and then wait at
.
least ten seconds.
Note: If the DIP switch is covered with the tape, make a hole in the
tape, and then set the DIP switch to the ON or OFF position.
5 Restore the DIP switch #3 (RTCRST) to the OFF position.
.
6 If removed mezzanine card at step 3, then reinstalling mezzanine card.
.
See
section.
7 Close the top cover of server blade. See
.
on page 5-39
8 Perform
.
Note: Replacing the lithium battery in the server blade results the server
blade EFI to the default configuration. After replacing the battery, restore the
configuration data. See

Replacing a SAS-kit 1 in half-wide server blade

This procedure describes how to remove a SAS-kit 1 from the server blade.
5-90
Replacing a mezzanine card in full-wide server blade on page 5-51
Figure 5-110 DIP switch #3 of CB 540A A1/B1
Figure 5-111 DIP switch #3 of CB 520X B1/B2/B3
Replacing a mezzanine card in half-wide server blade on page 5-49
section.
Installing a full-wide server blade on page 5-7
Backup/restore procedure on page 4-30
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Closing a top cover, Server blade
procedure.
section.