Hitachi CB 520H B1 Service Manual page 393

9 Repeat from step 4 to step 8 for all of the boot entries which was
.
indicated as Used before replacing the failed CNA product.
(Skip this step when the Boot BIOS setting for the first port is set to
Disabled.)
10 Press ESC. The window in step 3 is displayed again.
.
Move cursor onto Configure DCBX mode by using ↑ and ↓, and then
press Enter.
Move cursor onto the CEE mode or CIN mode as same setting as the
failed CNA product by using ↑ and ↓, and then press Enter.
Confirm that the DCBX mode is line changed to the selected mode.
(Skip this step when the BIOS setting for the first port is set to
Disabled.)
11 Press ESC. The window in step 3 is displayed again.
.
Move cursor onto Configure FCF CIN Parameters by using ↑ and ↓, and
then press Enter.
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
7-99