Installing A Lan Pass Through Module, Lan Pass Through Module2 - Hitachi CB 520H B1 Service Manual

3 Turn on LID LED for identifying the target module.
.
See
4 Turn on the maintenance mode from web console.
.
See
5 Power the target switch module off. See
.
page 4-62
6 Remove all cables for the failed module. If SFP+ modules are installed,
.
remove all of the SFP+ modules. See
5-114
7 Release the blue lock tab and then pull the lever, as shown below.
.
8 Holding the switch module, carefully slide out the switch module from the
.
chassis and place it on an anti-static mat.

Installing a LAN pass through module, LAN pass through module2

1 Put on an anti-static wrist strap.
.
2 Reverse the removal procedure to install the switch module.
.
3 Confirm that PWR LED emits in green on the replacing module.
.
When the 10Gb LAN pass through module inserting, the ST1 LED usually
blinks about 30 to 60 seconds during initialization, and then emits in
green.
4 Turn on LID LED for identifying the target module.
.
See
5 Verify that the replacement was successful through the MAR log.
.
See
6 Turn off the maintenance mode from web console.
.
See
7 Turn off LID LED for identifying the target module.
.
See
Identify LED (LID) on/off procedure on page 4-7
Maintenance mode on/off procedure on page 4-10
section.
section.
Figure 5-143 Removing a switch module
Identify LED (LID) on/off procedure on page 4-7
Alert information identification procedure on page 4-5
Maintenance mode on/off procedure on page 4-10
Identify LED (LID) on/off procedure on page 4-7
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
section.
Power off the switch module on
Removing an SFP+ module on page
section.
section.
section.
section.
5-113