Hitachi CB 520H B1 Service Manual page 100

Maintenance mode OFF for CB 520A A1, CB 520H A1/B1/B2/B3/B4, CB 540A
A1/B1, and Non-SMP CB 520X B1/B2/B3
1 Select Resources tab and select Modules > All Modules > Server
.
blades > a target blade that should be changed into maintenance
mode.
2 Click Action, and then select Maintenance mode OFF.
.
3 The current setting condition will be displayed. Click Confirm.
.
4 The confirmation dialog box appears. Click OK.
.
5 Confirm that the highlight of the selected module goes out and the
.
message is off.
Note: The server blade cannot boot OS as long as Maintenance mode ON is
activated.
Maintenance mode ON for SMP CB 520X B1/B2/B3
1 Select Resources tab and select Modules > All Modules > Server
.
blades.
2 Click Action, and then select Maintenance mode ON.
.
3 Click check boxes of the SMP blades that should be changed to
.
maintenance mode, and then click Confirm.
4 In Confirm dialog box, click OK.
.
5 Confirm that the selected blades highlighted and a symbol is indicated.
.
4-12
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual