Hitachi CB 520H B1 Service Manual page 174

3 Open a latch of the connector of the connection kit F/H in the PCI
.
expansion blade, and then pull out the connector straight upward.
See
4 Open two latches of the connection board in the server blade, and then
.
pull out the board straight upward.
See
5 (Skip this step when the connection kit L/P is not installed.)
.
Pull out the connector of the connection kit L/P in the PCI expansion blade
straight upward, and then turn over the connector toward server blade.
See
6 Loosen a thumbscrew of the connection bracket, and then remove the
.
bracket. See
5-24.
7 (Skip this step when the connection kit L/P is not installed.)
.
Pull out the connection board of the connection kit L/P in the server blade
straight upward. See
page
5-22
Figure 5-22 Removing the connection kit F/H on page
Figure 5-22 Removing the connection kit F/H on page
Figure 5-23 Removing the connection kit L/P on page
Figure 5-24 Removing the connection bracket on page
Figure 5-25 Removing the connection kit L/P on
5-24.
Figure 5-21 Location of the connection kit
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
5-23.
5-23.
5-23.