Removing A Full-Wide Server Blade - Hitachi CB 520H B1 Service Manual

15 Turn off LID LED for identifying the target blade. See
.
on/off procedure on page 4-7
Notice:
Do not install the server blade without the top cover. The server chassis
has a mechanical security to prevent installation without the top cover.
Bypassing this security feature can cause serious server chassis or server
blade damage.

Removing a full-wide server blade

1 Put on an anti-static wrist strap.
.
2 Connect Web console. See
.
section.
3 Power the target server blade off. See
.
4-58
4 Turn on LID LED for identifying the target blade. See
.
on/off procedure on page 4-7
5 Turn on the maintenance mode from web console. See
.
on/off procedure on page 4-10
6 Identify F/W version and take notes of it. See
.
procedure on page 4-22
7 When you remove a CB 520X B1/B2/B3 in SMP configuration, remove the
.
2-blade SMP connection board or 4-blade SMP connection board. See
Removing an SMP connection board on page 5-8
8 Release the blue lock tab and pull the lever, as shown below.
.
9 Holding the server blade, carefully slide out from the chassis and place it
.
on an anti-static mat.
Notice:
5-6
section.
Figure 5-3 Removing the full-wide server blade
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
Web console login procedure on page 4-3
Power down procedure on page
section.
section.
section.
Identify LED (LID)
Identify LED (LID)
Maintenance mode
F/W version identification
section.