Removing A Usb Memory; Installing A Usb Memory; Replacing A Dummy Module - Hitachi CB 520H B1 Service Manual

Removing a USB memory

1 Put on an anti-static wrist strap.
.
2 Remove the front panel module.
.
Refer to the
3 Pull out the USB memory from the USB connector and then remove it.
.

Installing a USB memory

1 Put on an anti-static wrist strap.
.
2 Reverse the removal procedure.
.
3 Install the front panel. See
.
section.

Replacing a dummy module

This procedure describes how to replace a dummy module. The dummy
module is a hot-swappable component and allows dummy module
replacement while the server chassis power on.
First, the procedures for removing dummy modules are provided.
At the end, the procedure for installing the new module is provided.
Notice:
The dummy module MUST be installed in all empty bays in the server
chassis. Operating the server chassis without the dummies can cause the
improper cooling and can lead to thermal damage for the modules.
Notice:
Do not leave a slot open for a long time. Leaving it open can cause the
overheat problem for other components.
5-126
Removing a front panel module on page 5-124
Figure 5-158 Removing the USB memory
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Installing a front panel module on page 5-125
section.