24
Enter firmwareshow, and then press Enter key. Confirm that the
.
version is newly downloaded FOS version.
10Gb DCB switch module
1
Click Start > Programs > Accessories > Communications >
.
HyperTerminal to boot up terminal software.
2
The Connection Description window is displayed. Enter telnet1, and
.
then click OK.
3
Select TCP/IP (Winsock), enter < IP address > in the Host address,
.
and then click OK.
< IP address >:IP address of the target switch module. See
address setup procedure for switch module on page 4-18
4
The login prompt is displayed in the terminal.
.
9-12
Updating firmware
Hitachi Compute Blade 500 Series System Service Manual
Internal IP
section.