Table of Contents
Advertisement
a. Extend the server from the rack.
b. Remove the server from the rack.
4.
Remove the access panel.
5.
Install the chassis intrusion detection switch behind the power supply bays.
6.
Install the access panel.
7.
Install the server in the rack.
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10. Power up the server.
Trusted Platform Module 2.0 guidelines
CAUTION:
•
Always observe the TPM guidelines in this section. Failure to follow these guidelines can cause
hardware damage or halt data access.
•
If you do not follow procedures for modifying the server and suspending or disabling the TPM in the
OS, an OS that is using TPM might lock all data access. This includes updating system or option
firmware, replacing hardware such as the system board and drives, and modifying TPM OS settings.
•
Changing the TPM mode after installing an OS might cause problems, including loss of data.
Hitachi Vantara Special Reminder: Before enabling TPM functionality on this system, you must ensure that
your intended use of TPM complies with relevant local laws, regulations and policies, and approvals or
licenses must be obtained if applicable.
Hardware options installation
108
Advertisement
Table of Contents
