Removing A Sd Card; Installing A Sd Card; Removing A Sd Card Enablement Kit - Hitachi CB 520H B1 Service Manual

Removing a SD card

Note: The indicator of the SD card location in the OS message varies
depending on the number of installed SD cards. Confirm the location of
replaced SD card depending on the following table.
1 Put on an anti-static wrist strap.
.
2 Remove the target server blade. See
.
on page 5-4
3 Open the top cover of the server blade. See
.
blade on page 5-38
4 When a mezzanine card is installed in mezzanine slot #1, remove the
.
mezzanine card. See
5 Push out the SD card from the SD card enablement kit.
.

Installing a SD card

1 Put on an anti-static wrist strap.
.
2 Reverse the removal procedure.
.

Removing a SD card enablement kit

1 Put on an anti-static wrist strap.
.
2 Remove the target server blade. See
.
on page 5-4
3 Open the top cover of the server blade. See
.
blade on page 5-38
4 When a mezzanine card is installed in mezzanine slot #1, remove the
.
mezzanine card. See
5 Loosen the two screws that hold the SD card enablement kit.
.
6 Remove the SD card enablement kit from the Server Blade.
.
7 Taken out from a SD card enablement kit guide.
.
section.
section.
Removing a mezzanine card on page 5-49
section.
section.
Removing a mezzanine card on page 5-49
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Removing a half-wide server blade
Opening a top cover, Server
Removing a half-wide server blade
Opening a top cover, Server
section.
section.
5-61