Removing A Connection Kit F/H - Hitachi CB 520H B1 Service Manual

5 Configure the parameters in the case of replacing Emulex HBA card.
.
See
6 Perform
.
procedure.

Removing a connection kit F/H

1 Put on an anti-static wrist strap.
.
2 Removing a server blade with a PCI expansion blade.
.
See
section.
3 Opening a top cover of server blade and storage expansion blade.
.
See
cover, PCI expansion blade on page 5-40
4 Open a latch of the connector of the connection kit F/H in the PCI
.
expansion blade, and then pull out the connector straight upward.
5 Open two latches of the connection board in the server blade, and then
.
pull out the board straight upward.
Configuration procedure for Emulex HBA card on page 7-2
Installing a PCI expansion blade into server chassis on page 5-16
Figure 5-93 Installing the mezzanine card
Removing a PCI expansion blade from server chassis on page 5-15
Opening a top cover, Server blade on page 5-38
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
and Opening a top
section.
section.
5-75