Note: Do not press and slide the cover surface.
Closing a top cover, PCI expansion blade
1
Reverse the removal procedure.
.
Replacing a DIMM in half-wide server blade
This procedure describes how to remove a DIMM from the server blade.
Removing a DIMM
1
Put on an anti-static wrist strap.
.
2
Remove the target server blade.
.
See
3
Open the top cover of the server blade.
.
See
4
When the SAS kit 2 is mounted in the server blade, remove the SAS kit 2
.
from the server Blade. See
5
Lift the air ducts, and remove them from the server blade assembly.
.
Figure 5-47 Opening the top cover
Removing a half-wide server blade on page 5-4
Opening a top cover, Server blade on page 5-38
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Removing a SAS-kit 2 on page 5-93
section.
section.
section.
5-41