Replacing A Dimm In Full-Wide Server Blade; Removing A Dimm - Hitachi CB 520H B1 Service Manual

Tip: Place the air duct with the airflow arrow facing back of the server
blade.
Do not care which the LEFT and RIGHT air ducts of CB 520H
A1/B1/B2/B3/B4 are as they are completely same.
7 Close the top cover. See
.
section.
8 Install the server blade. See
.
5-5
9 When the SAS kit 2 was mounted in the server blade, install the SAS kit 2
.
to the server blade. See

Replacing a DIMM in full-wide server blade

This procedure describes how to remove a DIMM from the server blade.

Removing a DIMM

1 Put on an anti-static wrist strap.
.
2 Remove the target server blade.
.
See
3 Open the top cover of the server blade.
.
See
Figure 5-55 Installing the USB enablement kit and air duct- CB
section.
Removing a full-wide server blade on page 5-6
Opening a top cover, Server blade on page 5-38
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
520H A1/B1/B2/B3/B4
Closing a top cover, Server blade on page 5-39
Installing a half-wide server blade on page
Installing a SAS-kit 2 on page 5-94 section.
section.
section.
5-45