Installing a USB
1
Put on an anti-static wrist strap.
.
2
Reverse the removal procedure.
.
Removing a USB enablement kit
1
Put on an anti-static wrist strap.
.
2
Remove the target server blade. See
.
on page 5-4
3
Open the top cover of the server blade. See
.
blade on page 5-38
4
Pull up the air duct portion of the USB enablement kit and remove it.
.
Figure 5-71 Removing the USB
section.
section.
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Removing a half-wide server blade
Opening a top cover, Server
5-57