Restoring switch mode of FC switch module
To restore the switch mode
When you have already connected to the FC switch remote console, skip from
step 1 to step 6.
1
Click Start > Programs > Accessories > Communications >
.
HyperTerminal to boot up terminal software.
2
The Connection Description window is displayed. Enter telnet1, and
.
then click OK.
3
Select TCP/IP (Winsock), enter < IP address > in the Host address
.
box, and then click OK.
< IP address >:IP address for the target switch module. See
address setup procedure for switch module on page 4-18
4
The login prompt is displayed in the terminal.
.
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual
Internal IP
section.
4-27