Replacing A Server Blade; Removing A Half-Wide Server Blade - Hitachi CB 520H B1 Service Manual

Replacing a server blade

The hot-swappable feature of the Hitachi Compute Blade 500 series system
allows server blade replacement with the server chassis power ON. This
procedure describes how to replace a server blade when the server chassis
power is on.

Removing a half-wide server blade

1 Put on an anti-static wrist strap.
.
2 Connect Web console. See
.
section.
3 Power the target server blade off. See
.
4-58
4 Turn on LID LED for identifying the target blade. See
.
on/off procedure on page 4-7
5 Turn on the maintenance mode from web console. See
.
on/off procedure on page 4-10
6 Identify F/W version and take notes of it. See
.
procedure on page 4-22
7 Release the blue lock tab and pull the lever, as shown below.
.
8 Holding the server blade, carefully slide out the server blade from the
.
chassis and place it on an anti-static mat.
Notice:
Do not leave a slot open for a long time. Leaving it open can cause the
overheat problem for other components.
5-4
section.
Figure 5-1 Removing the half-wide server blade
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Web console login procedure on page 4-3
Power down procedure on page
section.
section.
section.
Identify LED (LID)
Maintenance mode
F/W version identification