Installing A Usb Memory; Replacing A Power Supply Module - Hitachi CB 520H B1 Service Manual

13 Remove the USB memory.
.

Installing a USB memory

1 Put on an anti-static wrist strap.
.
2 Reverse the removal procedure.
.
3 Turn off LID LED for identifying the target module.
.
See
4 Turn off the maintenance mode from web console.
.
See

Replacing a power supply module

This procedure describes how to replace a power supply.
WARNING:
To prevent the risk of electrical shock, disconnect power cord before
removing power supply module.
CAUTION:
High temperature component.
Do not touch the power supply module after removing the power cord.
Wait 5 or more minutes before holding the power supply module to
reduce the risk of serious burn injuries from hot surfaces.
Figure 5-152 Removing a USB memory
Identify LED (LID) on/off procedure on page 4-7
Maintenance mode on/off procedure on page 4-10
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
section.
5-121