Confirming Switch Mode Of Fc Switch Module - Hitachi CB 520H B1 Service Manual

Confirming switch mode of FC switch module

To confirm the switch mode
1 Click Start > Programs > Accessories > Communications >
.
HyperTerminal to boot up terminal software.
2 The Connection Description window is displayed. Enter telnet1, and
.
then click OK.
3 Select TCP/IP (Winsock), enter < IP address > in the Host address
.
box, and then click OK.
< IP address >:IP address for the target switch module. See
address setup procedure for switch module on page 4-18
4 The login prompt is displayed in the terminal.
.
5 Enter admin as login name, and then press Enter key.
.
6 Enter password as password, and then press Enter key.
.
Figure 4-27 Connecting to FC switch module
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual
Internal IP
section.
4-25