Replacing A Management Module (Redundant); Removing A Management Module - Hitachi CB 520H B1 Service Manual

4 Close the top cover of the server blade. See
.
blade on page 5-39
5 Install a disk drive.
.
See
6 Install the target server blade.
.
See

Replacing a management module (redundant)

This procedure describes how to replace the management module under the
redundant configuration. Under this configuration, two management modules
are installed in a chassis.

Removing a management module

1 Put on an anti-static wrist strap.
.
2 Connect web console. See
.
section.
3 Turn on LID LED for identifying the target module.
.
See
4 Turn on the maintenance mode from web console.
.
See
5 Identify F/W version and take notes of it.
.
See
6 Shutdown the failed management module.
.
5-100
Figure 5-129 Installing SAS HDD kit
section.
Installing a disk drive on page 5-36
Installing a full-wide server blade on page 5-7
Identify LED (LID) on/off procedure on page 4-7
Maintenance mode on/off procedure on page 4-10
F/W version identification procedure on page 4-22
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Closing a top cover, Server
section.
Web console login procedure on page 4-3
section.
section.
section.
section.