Appearance Of The Brocade 10Gb Dcb Switch Module - Hitachi Compute Blade 2500 Getting Started Manual

Figure 2-26 Connectors and indicators of the 1/10Gb LAN switch module
1 1 Gb uplink ports 1 to 20
.
These LAN ports connect to external networks. There are two LEDs next
to each port.
¢
¢
2 10 Gb uplink ports 21 to 24
.
These LAN ports connect to external networks. There are two LEDs next
to each port.
¢
¢
3 ALM LED
.
This LED lights up when a failure occurs on the switch module.
4 LID LED
.
This LED identifies the switch module. You can turn this LED on or off
from the Web console. You can use this LED to easily identify the location
of the target switch module.
5 PWR LED
.
This LED lights up when the switch module is powered on. This LED is off
when the switch module is powered off.
6 Mini USB port
.
This port connects USB devices used for management. This port only
accepts devices that are exclusive to this switch module.

Appearance of the Brocade 10Gb DCB switch module

The appearance of the Brocade 10Gb DCB switch module is shown below.
2-22
The LED on the left(Link) lights up when a link to the network is
established.
The LED on the right(Tx/Rx) flashes when the module is
communicating via the network.
The LED on the left(Link) lights up when a link to the network is
established.
The LED on the right(Tx/Rx) flashes when the module is
communicating via the network.
CB 2500 Appearance
Hitachi Compute Blade 2500 Series Getting Started Guide