Regulatory Declarations And Disclaimers; Safety Compliance Statement; European Union (Eu) Certification; Ul/Csa Certification - Hitachi DS7000 Product Description Manual

Regulatory Declarations and Disclaimers

Safety Compliance Statement

This product is in compliance with the following directives:

European Union (EU) Certification

Low voltage directive 2014/35/EU: standard EN 60950-1

UL/CSA Certification

UL 60950 (USA)
CSA 60950 (Canada)

International Certification (Standard memory servers only)

Standard IEC 60950-1

Electromagnetic Compatibility Statement

This product is in compliance with the protection requirements of the following
directives:

EU Certification

EMC directive 2014/30/EU : standards EN 55022, EN 55024, EN61000-3-2,
EN 61000-3-3
Federal Communications Commission (FCC) Certification
(USA)
FCC Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Properly shielded and grounded cables and connectors must be used in order to
meet FCC emission limits. Neither the provider nor the manufacturer are
responsible for any radio or television interference caused by using other than
recommended cables and connectors or by unauthorized changes or
modifications to this equipment. Unauthorized changes or modifications could
void the user's authority to operate the equipment.
p‐2 Description Guide