Single Cable RS-232 Use STX
Enables/disables the ability of the scanner to use STX.
START / END
Enable STX
DEFAULT
Set Single Cable RS-232 STX Character
This feature selects the STX character.
To specify the STX Character:
1. Scan the START/END bar code.
2. Scan the bar code, SET SINGLE CABLE RS-232 STX CHARACTER below. You'll need
3. Scan the appropriate characters/digits from the keypad in
4. The scanner will automatically exit Programming Mode when the appropriate amount of
Product Reference Guide
PROGRAMMING bar codes
to cover any unused bar codes on this and the facing page to ensure the scanner reads only
the bar code you intend to scan.
decimal designation for the desired character. A table containing the ASCII Character Set
and their corresponding hex values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning decimal digits for each character. Pad all
numbers with leading zeroes to yield a three-digit entry (001-127). Thus, to set a single
character value of A, bar codes containing the digits '0', '6' and '5' must be scanned. The
selectable range for this option is any decimal value from 001 to 127.
digits have been scanned.
SET SINGLE CABLE RS-232 STX CHARACTER
Single Cable RS-232
Disable STX
that represent the
Appendix C
61