Sensormatic Eas Button; Camera Button; Mobile Commerce Button - Datalogic Magellan 9800i Product Reference Manual

Sensormatic EAS Button

The Sensormatic EAS Button (see item #2 in
Programming
scanner is enabled.
DURATION
Momentary
3 Seconds upon EAS
error
a.
b.
c.

Camera Button

The Camera Button (item #9 in
19.
Table 19. Camera Button Functions
PRESS
DURATION
1st Momentary
Press
2nd Momentary
Press

Mobile Commerce Button

With a momentary press, the Mobile Commerce Button (item #10 in
out of Mobile Commerce mode.
Product Reference Guide
section to configure the button to operate always, or only function when the
PRESS
FUNCTION
Manually initiates EAS deacti-
a
vation
Allows scanner to resume
function despite EAS system
failure (non-fatal error)
For use in Coupled Mode only
"Downstream" in this case is defined as being the downstream side of the scan window
from the direction of product flow, or scanning direction.
If the EAS failure corrects itself, blinking will stop and the EAS LED will turn green.
FUNCTION
Enables the Camera
Function
Captures Image
Figure 58) has configurable functions. Use the
Place the item with the EAS tag downstream
zontal scan window and push the button.
EAS Failure Mode is indicated
- EAS LED blinks ON/OFF red, scanning disabled.
- FRU Status LED Indicator blinks '9'
- Error tone is sounded for one second
Upon pressing the button for 3 seconds, the scanner
will sound 3 high-pitched beeps, then resume scan
function. The EAS LED and FRU Status LED will continue
blinking as above, but at a slower rate until EAS system
function is restored.
Figure 58) is used for multiple functions as listed in
Enables image capture mode for the unit.
Once in image capture mode, the second press captures the image.
COMMENT
b
of the hori-
c
by:
COMMENT
Figure 58) goes into and
Table
395