Enter/Exit Programming Mode
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable
volumes, with each volume increment adding approximately five decibels to the
previous level:
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
001901(CR)
Good Read Beep Volume = Medium Low
DEFAULT
001903(CR)
Good Read Beep Volume = Medium High
40
•
Low
•
Medium Low
•
Medium
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode barcode.
Good Read Beep Volume
•
Medium High
•
High
001900(CR)
Good Read Beep Volume = Low
001902(CR)
Good Read Beep Volume = Medium
001904(CR)
Good Read Beep Volume = High
Magellan™ 1500i