Upc-A Check Character Transmission - Datalogic Magellan 1500i Product Reference Manual

Enter/Exit Programming Mode

UPC-A Check Character Transmission

Enables/disables transmission of a UPC-A check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
00B701(CR)
UPC-A Check Character Transmission = Enable
122
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode barcode.
UPC-A Check Character Transmission
00B700(CR)
UPC-A Check Character Transmission = Disable
DEFAULT
Magellan™ 1500i