Upc-A Check Character Transmission - Datalogic Magellan 1500i Product Reference Manual

UPC-A

UPC-A Check Character Transmission

Enables/disables transmission of a UPC‐A check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
00B701(CR)
UPC-A Check Character Transmission = Enable
PRODUCT REFERENCE GUIDE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
NOTE
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
barcode.
ENTER/EXIT PROGRAMMING MODE
00B700(CR)
UPC-A Check Character Transmission = Disable
DEFAULT
131