Match Access-Group - Allied Telesis AT-8100L/8 User Manual

Chapter 101: Quality of Service (QoS) Commands

MATCH ACCESS-GROUP

1706
Syntax
match access-group
Parameters
group-name
Indicates a group name that was created with the IP-ACCESS
LIST command.
group-number
Indicates an IPv4 group number that was created with one of the
ACCESS-LIST commands. There are two ranges of group
numbers:
3000 to 3699: Specifies the ID number of an access control list
for a numbered IPv4 ACL.
4000 to 4699: Specifies the ID number of a numbered MAC
address IPv4 ACL.
Mode
Class Map mode
Description
Use this command to add an access list as a matching criteria to a class
map using an ACL group name or group number. Only IPv4 ACL access
lists are supported by this command.
Note
IPv6 group names are not supported by the MATCH ACCESS-
GROUP command.
Before you set the MATCH ACCESS-GROUP command, you must create
an access group with either a group name or group number. You may
want to consult the description in "Creating ACLs" on page 1521 for
detailed information about how to assign group names and numbers. See
below for the commands to create named and numbered IPv4 ACLs:
 To create a named IPv4 ACL, use "IP ACCESS-LIST" on page 1587.
 To create a numbered MAC access group, use "ACCESS-LIST (MAC
Address)" on page 1564.
group-name|group-number