Siemens SIMOVERT MASTERDRIVES Manual page 424

05.2006
8.2.10.7 Extended CBP2 diagnosis for start-up personnel
P711.x Display in r732.9..24 (32 bytes)
1 Output: PKW and setpoints from the master
2 Input: PKW and actual values to the master
3 Configuring telegram from the master
End identifier: 0x5A, 0xA5
50
51
52
53
54
55
56
4 Parameterizing telegram from the master
End identifier: 0x5A, 0xA5
60
61
62
63
64
65
66
P711.x r732.x
30 r732.9
r732.10
r732.11
r732.12
r732.13
r732.14
r732.15
r732.16
r732.17
Siemens AG 6SE7087-6QX70 (Version AG)
SIMOVERT MASTERDRIVES
Activation of the extended diagnosis with P711.x > 0
Image of the C1 master telegrams
Diagnosis of configuration and parameterization
Result of parameterizing telegram evaluation (see table)
Result of evaluating cross-traffic parameterization (see table)
Result of configuring telegram evaluation (see table)
PPO type 1-5; if free configuration, then 0xff
Length of the input data to the master (without PKW) in bytes
Length of the output data from the master (without PKW) in bytes
Double-word specifier setpoints
Double-word specifier actual values
Free memory in the multi-port RAM of the DPC31 in bytes
The value output in parameter P732.9 (P711.x = 30) arises due to bit-by-
bit OR linking of the following parameters. In the case of errors in the
block for cross-traffic parameterization, the detailed fault codes are to be
entered in parameter P732.10. Only if P732.10 contains the value 0 can
the clear causes of the fault be read out of P732.9. If P732.10 <> 0, the
content of P732.9 is falsified and the errors leading to abort cannot be
clearly determined!
Compendium Motion Control
Communication / PROFIBUS
Maximum 32 bytes
Maximum 32 bytes
Byte 0 – 31
Byte 32 - 63
Byte 64 - 95
Byte 96 - 127
Byte 128 - 159
Byte 160 - 191
Byte 192 - 223
Byte 224 - 244
Byte 0 – 31
Byte 32 - 63
Byte 64 - 95
Byte 96 – 127
Byte 128 – 159
Byte 160 – 191
Byte 192 – 223
Byte 224 – 244
8.2-137