Siemens SIMOVERT MASTERDRIVES Manual page 742

Technology Option F01
Table configuration
U615
CAUTION
9-94
A total of 400 table interpolation points can be defined [839.6]. These
can be used in one large table or several small ones.
U615 = 0 One table with
max. 400 interpolation
points
U615 = 1 Two tables with
max. 200 interpolation
points each
Four tables with
U615 = 2
max. 100 interpolation
points each
U615 = 3 Eight tables with
max. 50 interpolation
points each
U615 = 4 Variable involving a
maximum of eight tables
with a total of 400
interpolation points
2
Note E PROM capacity, not all interpolation values will be stored!
Owing to the different sizes of E
values will be stored in the E
2
The large E PROM is capable of storing all interpolation value
parameters.
2
The small E PROM can store only the parameters of interpolation
values that were available in versions <1.4x, but the parameters of new
values are stored only in the RAM.
Y
Y
Y
X
C
Y Y
X
Y
2
PROM, not all nine interpolation
2
PROM.
6SE7087-6QX70 (Version AG)
Compendium Motion Control
05.2006
X
Y
X X
Y Y Y
X X
Y Y Y Y Y Y
X X X X X X
Y Y
X
X
Siemens AG
SIMOVERT MASTERDRIVES
X
X
X