Siemens SIMOVERT MASTERDRIVES Manual page 3

10.2004
For START-UP of the unit, please refer to Section 3 "First Start up" in the operating
instructions supplied with the inverters/converters.
In the following, we would like to give you some tips on how to proceed further and how to use
the COMPENDIUM for detailed PARAMETERIZATION of the units.
Preparatory measures for detailed parameterization
Make yourself familiar with the connection diagrams of the power and control terminals:
You can find these in the operating instructions for the units and options in the section
"Connecting-up" (in the case of optional boards, consult the "Description" section as well).
The operating instructions are supplied with the units.
Make yourself familiar with the basic functions of the units (brief introduction):
see the following sections in this Compendium:
♦ Section 4: "Function blocks and parameters"
(blocks, connectors, binectors, parameters, data sets, BICO system)
♦ Sections 5.1 to 5.3: "Parameterization"
(parameter menus, operator control and displays on the PMU (operator control panel))
(Section 5.4 "Parameter input via the OP1S" only if necessary)
DETAILED PARAMETERIZATION (COMPENDIUM):
GENERAL TIPS
♦ The units can be parameterized with the PMU / OP1S (operator control panels) or with a
PC and the DriveMonitor software package.
♦ If you need more detailed information about specific parameters, connectors or binectors,
you can find a "parameter list", with a connector and binector list added onto the end,
plus an overview of the data-set parameters (assignment of the indices) in the appendix
(Volume 2) of the Compendium.
(Please note the "Explanations" at the beginning of the parameter list!)
These lists can be used as a reference whenever necessary.
♦ If faults or alarms occur during start-up (Fxxx , Axxx), you can find detailed descriptions of
them in the appendix (Volume 2) under "Faults and Alarms".
♦ The units are delivered with their factory setting.
If you want to restore the factory setting in the case of a repeat start-up, incorrect inputs or
a change between the type of start-up indicated below (Sections 1.), 2.) and 3.)), this can
be done at any time with the function described in Section 6.1, "Parameter reset to factory
setting".
(Abbreviated instructions:
The following are the different types of start-up. In the annex, there are some tips on
information to be found in the internet.
1.) Paramterization of the basic unit during initial start-up
2.) Parameterization of the F01 technology option (if present) during initial start-up
3.) Parameterization of the unit by means of downloading if data backup is provided
♦
Annex (tips on information in the internet)
Siemens AG 6SE7087-6QX70 (Version AD)
SIMOVERT MASTERDRIVES
P053 = 6 > P060 = 2 > P970 = 0)
Motion Control Compendium
Guidelines for Start-Up
1