Siemens SIMOVERT MASTERDRIVES Manual page 133

02.2007
6.2.2 Board configuration
P060 = 4
SCB inserted ?
yes
no
P696 = ?
CBx inserted ?
no
P711.1...2 = ?
to
P721.1...10 = ?
Siemens AG 6SE7087-6QX70 (Version AH)
SIMOVERT MASTERDRIVES
During board configuration, the control electronics is informed in what
way the installed optional boards have to be configured. This step is
always necessary when optional boards CBx or SLB are used.
The unit must be switched to the "Board configuration" status for this
purpose. This is done by selecting the "Board configuration" menu. In
this menu, parameters are set that are required for adapting the
optional boards to the specific application (e.g. bus addresses, baud
rates, etc.). After leaving the menu, the set parameters are transferred
and the optional boards are initialized.
Select "Board configuration" menu
NOTE: Only possible with CUPM.
Not with Compakt PLUS units.
SCB protocol
0: SCI
1: USS 4-wire
2: USS 2-wire
3: Peer-to-Peer
yes
Enter the CB parameters 1 to 11 necessary for the inserted
communications boards CBx
The necessary CB parameters and their significance can be
derived from the function diagrams of the individual
communications boards.
Compendium Motion Control
Parameterizing Steps
6-11