Siemens SIMOVERT MASTERDRIVES Manual page 911

OP OperDisp OP OperDisp OP OperDisp
4th line 3rd line (set) 2nd line (actual)
0 ... 3999 0 ... 3999
P049.05 (1) P049.04 (229) P049.03 (230)
The control commands are transferred via word 1 in the USS protocol.
B2100 ON/OFF1 from OP1S
B2101 OFF2 from OP1S
I 0
B2102 OFF3 from OP1S
B2113 Raise MOP from OP1S
B2114 Lower MOP from OP1S
B2111 Positive direction of rotation from OP1S
B2112 Negative direction of rotation from OP1S
B2107 Acknowledgement from OP1S
Reset
Jog B2108 Inching from OP1S
Connection to control word. See [180.3]
For operation and BICO wiring of OP1S please see Chapter 5.4.3.
1 2
OP1S
Operating display
OP OperDisp OP OperDisp
1st line left 1st line right
0 ... 3999 0 ... 3999 0 ... 3999
P049.01 (4) P049.02 (6)
3
- A maximum of 6 characters (value + unit) are available for the
Active node
display in P049.01 and P049.02 respectively.
(= bus address)
- The 2nd line (P049.03) is for the display of actual values.
- The 3rd line (P049.04) is for the display of setpoints.
Only setting parameters can be entered here.
OP Backlight
P361
P053 Parameter Access
Bit 2 = 1
xxx xxxx xxxx x1xx
ON key
OFF key
Inching key
4 5
V2.4
0: Deutsch
1: English
P050
2: Español
Language
3: Français
4: Italiano
LCD (4 lines x 16 characters)
Fault
Run
Reversing key
I
Raise key
0
P Lower key
Key for toggling between control levels
Jog 7 8 9
4 5 6 0 to 9: number keys
1 2 3
Reset key
0 +/- Reset
Sign key
6 7
Function diagram
fp_mc_060_e.vsd
MASTERDRIVES MC
12.08.04
n959.16 = 4
8
- 60 -