Siemens SIMOVERT MASTERDRIVES Manual page 798

Technology Option F01
9-150
Fig. 9-55 Activation of the equidistance on the converter
On tab card "General" you can check the baud rate. If it is not 12
Mbit/s, you can set it under Properties, Network settings.
Please note:
If the CPU is reset, communication via your PROFIBUS interface is not
possible.
You must load the hardware configuration into the CPU via the MPI
interface. After that, communication via the PROFIBUS interface will be
possible again. If you reset the CPU via the PROFIBUS interface,
communication is interrupted.
If you address the PLC via the MPI or PROFIBUS interface, you must
select the PG/PC interface in the SIMATIC Manager under "Extras".
6SE7087-6QX70 (Version AG)
Compendium Motion Control
05.2006
Siemens AG
SIMOVERT MASTERDRIVES