Siemens SIMOVERT MASTERDRIVES Manual page 566

02.2004
No.
0 Illegal parameter number (PNU)
1 Parameter value cannot be changed
2 Lower or upper value limit exceeded
3 Errored subindex
4 Not an array
5 Incorrect data type
6 Setting not allowed (resetting only)
7 Description element cannot be changed
11 No control command source status
12 Keyword missing
15 Text array does not exist
17 Task cannot be executed in current
operating state
101 Parameter number currently deactivated
102 Channel not wide enough
103 Incorrect number of PKWs
104 Illegal parameter value
105 The parameter is indexed
106 Task not implemented
107 Text cannot be changed
108 Number of PWEs <> index number
Siemens AG 6SE7087-6QX70 (Version AD)
SIMOVERT MASTERDRIVES
Table of error values
Meaning
If no PNU is connected at all
If the parameter is a visualization parameter
-
-
In response to tasks for indexed parameters addressed to
a nonindexed parameter.
E.g. task: "Change parameter value (word, array)" for
nonindexed parameter
-
-
Task cannot be executed on MASTERDRIVES
-
Device parameter: "Access key" and/or "Par. special
access" not appropriately set
-
Current converter status prohibits execution of transmitted
task
-
1)
Parameter response too long for CAN message
Error cannot occur on CBC
2)
-
In response to tasks for nonindexed parameters
addressed to an indexed parameter.
E.g. task: "Change PWE word" for indexed parameter
-
-
-
1) This error number is transferred if the parameter response to a parameter task is
longer than the available 8 bytes of CAN data message which means that it
cannot be sent. The data are not divided up between data messages.
2) This error number is transferred if no function is assigned in the device to the
parameter to be passed or if it cannot currently be accepted for internal reasons
(although it is within legal limits).
Compendium Motion Control
Communication / CBC CANopen Communication Board
8.5-51